03-25-2011 01:24 AM - edited 03-04-2019 11:52 AM
Hi folks,
I recently noticed OSPF behavior, which I don´t understad - routes are in routing table, but I don´t see them in OSPF database.
s100_unl_vtp#sh ip route 10.100.254.1
Routing entry for 10.100.254.1/32
Known via "ospf 100", distance 110, metric 2, type intra area
Last update from 10.100.248.1 on Vlan1000, 2w3d ago
Routing Descriptor Blocks:
* 10.100.248.1, from 10.251.254.100, 2w3d ago, via Vlan1000
Route metric is 2, traffic share count is 1
s100_unl_vtp#sh ip ospf database | i 10.100.254.1
s100_unl_vtp#
router ospf 100
log-adjacency-changes
area 100 nssa
redistribute static subnets
network 10.100.0.0 0.0.255.255 area 100
Basically I don´t see most of LSA from this router´s "own" area I would expect - there should be a lot of type 2 LSAs from end user LANs, but there are none. Everything is working fine, I am just confused, as routing table should be just the best routes picked from OSPF database, right?
Thanks,
Martin
Solved! Go to Solution.