I'd like to setup Port/VLAN mirroring on my SG300. I see the place in the Diagnostics where to do it.
I selected a Port, Made sure it was not part of any VLAN, then designated it as the Destination Port. then Took my Two Trunk VLAN Tagged Ports and Pointed them to the Destination Port. I loaded up Network Monitor and I got some Traffic, but seemed to all be Broadcast/ARP requests.
I then mirrored the other non Tagged Ports to the Destination port. I jsut got moreBroadcast/ARP requests traffic. I expected to see Everthing that was going through that switch...
This switch is connected to our Edge Router via two VLANs. I was hoping to see ALL the traffic to/From the Net from here.
Suggestions?
Thanks!
