cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Who Me Too'd this topic

Cisco 881G 3G interface config.

jopetik09
Level 1
Level 1

Hi All,

I have a router Cisco 881G, DSL was running.
Yesterday we got 3G, now I need to config to get work 3G and also failover between DSL and 3G.
I hope someone will provide me step by step to achive above would be appreciate.

Below are some outputs for more inforamiton:

#sh cellular 0 secu
Card Holder Verification (CHV1) = Enabled
SIM Status = Locked
SIM User Operation Required = Enter CHV1
Number of Retries remaining = 3


#sh cellular 0 profil
Profile 1 = INACTIVE*
--------
PDP Type = IPv4
Access Point Name (APN) = web.vodafone.de
Authentication = CHAP
Username: internet, Password: tm

* - Default profile


#sh int cell
CuxhavenRTR#sh int cellular 0
Cellular0 is down, line protocol is down
  Hardware is 3G Modem-HSPA/UMTS/EDGE/GPRS-850/900/1800/1900/2100MHz / Global
  MTU 1500 bytes, BW 384 Kbit/sec, DLY 100000 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation PPP, LCP Closed, loopback not set
  Keepalive not supported
  Last input never, output never, output hang never
  Last clearing of "show interface" counters 1w5d
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: weighted fair
  Output queue: 0/1000/64/0 (size/max total/threshold/drops)
     Conversations  0/0/16 (active/max active/max total)
     Reserved Conversations 0/0 (allocated/max allocated)
     Available Bandwidth 288 kilobits/sec
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     0 packets input, 0 bytes, 0 no buffer
     Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
     0 packets output, 0 bytes, 0 underruns
     0 output errors, 0 collisions, 6 interface resets
     0 unknown protocol drops
     0 output buffer failures, 0 output buffers swapped out
     0 carrier transitions
     DCD=up  DSR=up  DTR=up  RTS=up  CTS=up

#sh cellular 0 net
Current Service Status = Emergency Only, Service Error = None
Current Service = Invalid
Packet Service = None
Packet Session Status = Inactive
Current Roaming Status = Home
Network Selection Mode = Automatic
Country = DEU, Network = TMO D
Mobile Country Code (MCC) = 262
Mobile Network Code (MNC) = 1
Location Area Code (LAC) = 16683
Routing Area Code (RAC) = 1
Cell ID = 4370
Primary Scrambling Code = 347
PLMN Selection = Automatic
Available PLMNs:
PLMN Name = T-Mobile D (TMO D)
        MCC = 262, MNC = 1
        Status = , Network = Unknown

PLMN Name = o2 - de (o2 - de)
        MCC = 262, MNC = 7
        Status = Supports GPRS, Network = GSM

PLMN Name = Vodafone.de (Voda de)
        MCC = 262, MNC = 2
        Status = , Network = GSM

PLMN Name = T-Mobile D (TMO D)
        MCC = 262, MNC = 1
        Status = , Network = GSM

PLMN Name = Vodafone.de (Voda de)
        MCC = 262, MNC = 2
        Status = , Network = Unknown

PLMN Name = E-Plus (E-Plus)
        MCC = 262, MNC = 3
        Status = , Network = Unknown

PLMN Name = o2 - de (o2 - de)
        MCC = 262, MNC = 7
        Status = , Network = Unknown

PLMN Name = E-Plus (E-Plus)
        MCC = 262, MNC = 3
        Status = , Network = GSM

Thanks in advance.
Jopeti.

Who Me Too'd this topic