I have a 3560 switch running: version 12.2(55)SE3 image: c3560e-universalk9-mz.122-55.SE3.
I can ssh into the switch from a remote pc just fine using usernames and passwords.
I want to use keys so that the ssh does not prompt me for login info.
under my switch when I a in config t mode, I do not see the commands for: ip ssh pubkey-chain
I only have the following options under ip ssh
- authentication-retires
- dscp
- logging
- precedence
- source-interface
- time-out
- version
All the documation i see has procedures for entering ip ssh pubkey-chain ...... but I don't get that option.
I thought the K9 image supported this? What have I not turned on for the options to appear?
As I said, I can ssh into the box fine, but when I follow a procedure for enabling ssh keys I don't get the commands they say should be available.
Thanks
