07-26-2012 11:36 AM - edited 07-03-2021 10:27 PM
Here is the full rundown of the bootup and (attempted image load from the lap):
IOS Bootloader - Starting system.
flash is writable
FLASH CHIP: Numonyx Mirrorbit (0089)
Xmodem file system is available.
flashfs[0]: 4 files, 3 directories
flashfs[0]: 0 orphaned files, 0 orphaned directories
flashfs[0]: Total bytes: 31997952
flashfs[0]: Bytes used: 3364864
flashfs[0]: Bytes available: 28633088
flashfs[0]: flashfs fsck took 12 seconds.
Reading cookie from SEEPROM
Base Ethernet MAC address: a4:93:4c:c1:1d:5c
Ethernet speed is 1000 Mb - FULL Duplex
Loading "flash:/ap3g2-rcvk9w8-mx.124-23c.JY/ap3g2-rcvk9w8-mx.124-23c.JY"...###################################################################################################################################################################
File "flash:/ap3g2-rcvk9w8-mx.124-23c.JY/ap3g2-rcvk9w8-mx.124-23c.JY" uncompressed and installed, entry point: 0x2003000
executing...
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco IOS Software, C3600 Software (AP3G2-RCVK9W8-M), Version 12.4(23c)JY, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2011 by Cisco Systems, Inc.
Compiled Wed 26-Oct-11 19:21 by prod_rel_team
Proceeding with system init
Proceeding to unmask interrupts
Initializing flashfs...
FLASH CHIP: Numonyx Mirrorbit (0089)
flashfs[1]: 4 files, 3 directories
flashfs[1]: 0 orphaned files, 0 orphaned directories
flashfs[1]: Total bytes: 31739904
flashfs[1]: Bytes used: 3364864
flashfs[1]: Bytes available: 28375040
flashfs[1]: flashfs fsck took 7 seconds.
flashfs[1]: Initialization complete.
flashfs[2]: 0 files, 1 directories
flashfs[2]: 0 orphaned files, 0 orphaned directories
flashfs[2]: Total bytes: 11999232
flashfs[2]: Bytes used: 1024
flashfs[2]: Bytes available: 11998208
flashfs[2]: flashfs fsck took 0 seconds.
flashfs[2]: Initialization complete....done Initializing flashfs.
This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to
%Error opening flash:/ap3g2-rcvk9w8-mx/info (No such file or directory)cisco AIR-CAP3602I-A-K9 (PowerPC) processor (revision B0) with 167926K/81920K bytes of memory.
Processor board ID FTX1625GNE8
PowerPC CPU at 800Mhz, revision number 0x2151
Last reset from power-on
LWAPP image version 7.0.114.214
1 Gigabit Ethernet interface
32K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address: A4:93:4C:C1:1D:5C
Part Number : 73-14521-01
PCA Assembly Number : 800-37501-01
PCA Revision Number : A0
PCB Serial Number : FOC16223RVZ
Top Assembly Part Number : 800-35852-02
Top Assembly Serial Number : FTX1625GNE8
Top Revision Number : A0
Product/Model Number : AIR-CAP3602I-A-K9
% Please define a domain-name first.
logging facility kern
^
% Invalid input detected at '^' marker.
Press RETURN to get started!
*Mar 1 00:00:09.311: %LWAPP-3-CLIENTEVENTLOG: Unable to open event log file flash:/event.log
*Mar 1 00:00:09.311: %LWAPP-3-CLIENTEVENTLOG: Read and initialized AP event log (contains, 0 messages)
*Mar 1 00:00:11.235: %LINK-3-UPDOWN: Interface GigabitEthernet0, changed state to up
*Mar 1 00:00:11.251: %SYS-5-RESTART: System restarted --
Cisco IOS Software, C3600 Software (AP3G2-RCVK9W8-M), Version 12.4(23c)JY, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyrig
APa493.4cc1.1d5c>ht (c) 1986-2011 by Cisco Systems, Inc.
Compiled Wed 26-Oct-11 19:21 by prod_rel_team
*Jun 11 00:27:35.027: %CAPWAP-5-CHANGED: CAPWAP changed state to DISCOVERY
*Jun 11 00:27:35.979: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0, changed state to downDPAA Initialization Complete
*Jun 11 00:27:37.627: %SYS-3-HARIKARI: Process DPAA INIT top-level routine exited
*Jun 11 00:27:38.627: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0, changed state to up
*Jun 11 00:27:48.251: %DHCP-6-ADDRESS_ASSIGN: Interface GigabitEthernet0 assigned DHCP address 192.168.0.233, mask 255.255.255.0, hostname APa493.4cc1.1d5c
*Jun 11 00:27:57.451: %CDP_PD-2-POWER_LOW: All radios disabled - INJECTOR_DETECTED_PD AIR-CAP3602E-A-K9 (0000.0000.0000)
Translating "CISCO-CAPWAP-CONTROLLER"...domain server (192.168.0.1)
Translating "CISCO-LWAPP-CONTROLLER"...domain server (192.168.0.1)
*Jul 26 18:12:02.000: %CAPWAP-5-DTLSREQSEND: DTLS connection request sent peer_ip: 192.168.0.2 peer_port: 5246
*Jul 26 18:12:02.999: %CAPWAP-5-CHANGED: CAPWAP changed state to
*Jul 26 18:12:03.499: %CAPWAP-5-DTLSREQSUCC: DTLS connection created sucessfully peer_ip: 192.168.0.2 peer_port: 5246
*Jul 26 18:12:03.499: %CAPWAP-5-SENDJOIN: sending Join Request to 192.168.0.2
*Jul 26 18:12:03.499: %CAPWAP-5-CHANGED: CAPWAP changed state to JOIN
examining image...
*Jul 26 18:12:08.499: %CAPWAP-5-SENDJOIN: sending Join Request to 192.168.0.2perform archive download capwap:/ap3g2 tar file
*Jul 26 18:12:08.511: %CAPWAP-6-AP_IMG_DWNLD: Required image not found on AP. Downloading image from Controller.
*Jul 26 18:12:08.515: %CAPWAP-5-CHANGED: CAPWAP changed state to IMAGE
*Jul 26 18:12:08.515: Loading file /ap3g2...
logging facility kern
^
% Invalid input detected at '^' marker.
%Error opening flash:/update/info (No such file or directory)
ERROR: Image is not a valid IOS image archive.
archive download: takes 48 seconds
*Jul 26 18:12:56.567: %DTLS-5-SEND_ALERT: Send FATAL : Close notify Alert to 192.168.0.2:5246
*Jul 26 18:12:56.567: %CAPWAP-5-CHANGED: CAPWAP changed state to DISCOVERY
*Jul 26 18:12:56.567: %CAPWAP-5-CHANGED: CAPWAP changed state to DISCOVERY
*Jul 26 18:12:56.627: %CAPWAP-3-ERRORLOG: capwap ifs: read error or timeout
*Jul 26 18:12:56.635: capwap_image_proc: problem extracting tar file
*Jul 26 18:13:06.000: %CAPWAP-5-DTLSREQSEND: DTLS connection request sent peer_ip: 192.168.0.2 peer_port: 5246
*Jul 26 18:13:06.000: %CAPWAP-5-CHANGED: CAPWAP changed state to
*Jul 26 18:13:06.495: %CAPWAP-5-DTLSREQSUCC: DTLS connection created sucessfully peer_ip: 192.168.0.2 peer_port: 5246
*Jul 26 18:13:06.499: %CAPWAP-5-SENDJOIN: sending Join Request to 192.168.0.2
*Jul 26 18:13:06.499: %CAPWAP-5-CHANGED: CAPWAP changed state to JOIN
This is from the logs on the wlc:
*spamApTask7: Jul 26 14:32:11.044: %CAPWAP-3-TX_ERR: capwap_ac_sm.c:4172 The system has failed to transmit image data request to AP 2c:54:2d:9c:a1:f9
*spamApTask7: Jul 26 14:32:11.044: %CAPWAP-3-ENCODE_ERR: capwap_ac_sm.c:2425 The system has failed to encode Image data request to AP 2c:54:2d:9c:a1:f9
*spamApTask7: Jul 26 14:32:11.044: %CAPWAP-3-IMAGE_DOWNLOAD_ERR3: capwap_ac_platform.c:782 Refusing image download request from AP - unable to open image file /bsn/ap//ap3g2
Any ideas?
I have so far:
Tried mac filtering for this particular ap, as well as two others.
verified auth vs mic was enabled with appropriate mac entered, and removed it as well.
The wlc is set as the master.
Solved! Go to Solution.