09-28-2012 10:55 AM - edited 03-17-2019 11:53 PM
After adding an MXP codec to my Network and editing the system settings in TMS I could not connect b/c it was preset to "Behind Firewall."
When I change the connectivity in TMS to Reachable on LAN i get a system status of No Http response. And then lose the ability to adjust system settings in TMS. Do i need to adjust the http and https ports? If so, I can't find where to do this in the codec settings nor in TMS.
I'm only new to troubleshooting Tandberg Codecs, and am more familiar with the Polycom environment.