10-10-2012 09:27 PM - edited 03-07-2019 09:23 AM
Hi,
We recently purchased a Catalyst 4510R-E switches with 4 x 10 GB Module (SFP-10G-SR) but we unable to use the TenGigabitEthernet transceiver. Is there any special command to make the 10GB Transceiver work? It keep showing Inactive/Not Connected. But when we use 1GB Transceiver it working fine.
We tried the following Scenario but no luck at all:-
Source:-
Nexus7000 C7010
Port Configuration
interface Ethernet2/21
description Testing Purpose
switchport mode trunk
switchport trunk allowed vlan 1,3,888
no shutdown
Tested with 1GB, 10GB Transceiver, OM2 and OM3 fiber optic cable.
Destination:-
Catalyst 4510R-E
Port Configuration
interface TenGigabitEthernet5/2
switchport mode trunk
end
Tested with 1GB Transceiver (OM2 and OM3 fiber optic cable) and it working fine.
Failed with 10GB Transceiver (SFP-10G-SR)
Version:-
show version
Cisco IOS Software, IOS-XE Software, Catalyst 4500 L3 Switch Software (cat4500e- UNIVERSALK9-M), Version 03.03.00.SG RELEASE SOFTWARE
(fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2012 by Cisco Systems, Inc.
Compiled Sun 15-Apr-12 08:06 by prod_rel_team
ROM: 15.0(1r)SG5
SGSGACDS03 uptime is 2 hours, 9 minutes
Uptime for this control processor is 2 hours, 11 minutes
System returned to ROM by power-on
Running default software
Jawa Revision 7, Snowtrooper Revision 0x0.0x1C
This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to
License Information for 'WS-X45-SUP7-E'
License Level: ipbase Type: Permanent
Next reboot license Level: ipbase
cisco WS-C4510R+E (MPC8572) processor (revision 10) with 2097152K/20480K bytes o f memory.
Processor board ID FXS1636Q13S
MPC8572 CPU at 1.5GHz, Supervisor 7
Last reset from PowerUp
2 Virtual Ethernet interfaces
192 Gigabit Ethernet interfaces
8 Ten Gigabit Ethernet interfaces
511K bytes of non-volatile configuration memory.
Configuration register is 0x2101
Solved! Go to Solution.