Hi, all,
I've havving problems with mi E1 R2_Digital voice port, the problem is that the calls cannot go in, but calls from IP Phones to PSTN can go out,
I wrote some debugs commands, with this error on the VMP command.
Jan 3 17:46:26.643: R2 Incoming Voice(0/0): DSX (E1 0/0/0:0): STATE: R2_IN_CALLERID R2 Got Event R2_TONE_OFF
Jan 3 17:46:26.643: r2_reg_generate_digits(0/0/0:0(1)): Tx digit '#'
Jan 3 17:46:26.743: htsp_digit_ready_up(0/0/0:0(1)): Rx digit='5'
Jan 3 17:46:26.743: R2 Incoming Voice(0/0): DSX (E1 0/0/0:0): STATE: R2_IN_CALLERID R2 Got Event 5
Jan 3 17:46:26.743: r2_reg_generate_digits(0/0/0:0(1)): Tx digit '1'
Jan 3 17:46:26.835: htsp_digit_ready(0/0/0:0(1)): Rx digit='#'
Jan 3 17:46:26.835: R2 Incoming Voice(0/0): DSX (E1 0/0/0:0): STATE: R2_IN_CALLERID R2 Got Event R2_TONE_OFF
Jan 3 17:46:26.835: r2_reg_generate_digits(0/0/0:0(1)): Tx digit '#'
Jan 3 17:46:26.923: htsp_digit_ready_up(0/0/0:0(1)): Rx digit='1'
Jan 3 17:46:26.923: R2 Incoming Voice(0/0): DSX (E1 0/0/0:0): STATE: R2_IN_CALLERID R2 Got Event 1
Jan 3 17:46:26.923: r2_reg_generate_digits(0/0/0:0(1)): Tx digit '1'
Jan 3 17:46:27.015: htsp_digit_ready(0/0/0:0(1)): Rx digit='#'
Jan 3 17:46:27.015: R2 Incoming Voice(0/0): DSX (E1 0/0/0:0): STATE: R2_IN_CALLERID R2 Got Event R2_TONE_OFF
Jan 3 17:46:27.015: r2_reg_generate_digits(0/0/0:0(1)): Tx digit '#'
Jan 3 17:46:27.103: htsp_digit_ready_up(0/0/0:0(1)): Rx digit='3'
Jan 3 17:46:27.103: R2 Incoming Voice(0/0): DSX (E1 0/0/0:0): STATE: R2_IN_CALLERID R2 Got Event 3
Jan 3 17:46:27.103: r2_reg_generate_digits(0/0/0:0(1)): Tx digit '1'
Jan 3 17:46:27.195: htsp_digit_ready(0/0/0:0(1)): Rx digit='#'
Jan 3 17:46:27.195: R2 Incoming Voice(0/0): DSX (E1 0/0/0:0): STATE: R2_IN_CALLERID R2 Got Event R2_TONE_OFF
Jan 3 17:46:27.195: r2_reg_generate_digits(0/0/0:0(1)): Tx digit '#'
Jan 3 17:46:27.283: htsp_digit_ready_up(0/0/0:0(1)): Rx digit='0'
Jan 3 17:46:27.283: R2 Incoming Voice(0/0): DSX (E1 0/0/0:0): STATE: R2_IN_CALLERID R2 Got Event 10
Jan 3 17:46:27.283: r2_reg_generate_digits(0/0/0:0(1)): Tx digit '1'
Jan 3 17:46:27.375: htsp_digit_ready(0/0/0:0(1)): Rx digit='#'
Jan 3 17:46:27.375: R2 Incoming Voice(0/0): DSX (E1 0/0/0:0): STATE: R2_IN_CALLERID R2 Got Event R2_TONE_OFF
Jan 3 17:46:27.375: r2_reg_generate_digits(0/0/0:0(1)): Tx digit '#'
Jan 3 17:46:27.463: htsp_digit_ready_up(0/0/0:0(1)): Rx digit='0'
Jan 3 17:46:27.463: R2 Incoming Voice(0/0): DSX (E1 0/0/0:0): STATE: R2_IN_CALLERID R2 Got Event 10
Jan 3 17:46:27.463: r2_reg_generate_digits(0/0/0:0(1)): Tx digit '1'
Jan 3 17:46:27.555: htsp_digit_ready(0/0/0:0(1)): Rx digit='#'
Jan 3 17:46:27.555: R2 Incoming Voice(0/0): DSX (E1 0/0/0:0): STATE: R2_IN_CALLERID R2 Got Event R2_TONE_OFF
Jan 3 17:46:27.555: r2_reg_generate_digits(0/0/0:0(1)): Tx digit '#'
Jan 3 17:46:27.643: htsp_digit_ready_up(0/0/0:0(1)): Rx digit='0'
Jan 3 17:46:27.643: R2 Incoming Voice(0/0): DSX (E1 0/0/0:0): STATE: R2_IN_CALLERID R2 Got Event 10
Jan 3 17:46:27.643: r2_reg_generate_digits(0/0/0:0(1)): Tx digit '5'
Jan 3 17:46:27.735: htsp_digit_ready(0/0/0:0(1)): Rx digit='#'
Jan 3 17:46:27.735: R2 Incoming Voice(0/0): DSX (E1 0/0/0:0): STATE: R2_IN_COLLECT_DNIS R2 Got Event R2_TONE_OFF
Jan 3 17:46:27.735: r2_reg_generate_digits(0/0/0:0(1)): Tx digit '#'
Jan 3 17:46:27.859: htsp_process_event: [0/0/0:0(1), R2_Q421_IC_WAIT_ANSWER, E_DSP_SIG_1000]
Jan 3 17:46:27.859: r2_q421_ic_clr_fwd_idle(0/0/0:0(1)) Rx CLEAR FWD
Jan 3 17:46:27.859: r2_reg_channel_disconnected(0/0/0:0(1))
Jan 3 17:46:27.859: R2 Incoming Voice(0/0): DSX (E1 0/0/0:0): STATE: R2_IN_COLLECT_DNIS R2 Got Event R2_STOP
Jan 3 17:46:27.859: r2_reg_generate_digits(0/0/0:0(1)): Tx digit '#'
Jan 3 17:46:27.859: htsp_timer - 2000 msec
Jan 3 17:46:27.859: htsp_process_event: [0/0/0:0(1), R2_Q421_IC_CLR_FWD, E_HTSP_RELEASE_REQ]
Jan 3 17:46:27.859: r2_q421_null_release(0/0/0:0(1)) E_HTSP_RELEASE_REQ
Jan 3 17:46:27.859: r2_reg_process_event: [0/0/0:0(1), R2_REG_COLLECTING, E_R2_REG_DISCONNECT(91)]
Jan 3 17:46:27.859: r2_reg_disconnect_collect(0/0/0:0(1))
Jan 3 17:46:27.859: r2_reg_timer_stop(0/0/0:0(1))
Jan 3 17:46:29.859: htsp_process_event: [0/0/0:0(1), R2_Q421_IC_CLR_FWD, E_HTSP_EVENT_TIMER]
Jan 3 17:46:29.859: htsp_timer_stop
Jan 3 17:46:29.859: r2_q421_clr_fwd_idle(0/0/0:0(1)) Tx IDLEvnm_dsp_set_sig_state:[R2 Q.421 0/0/0:0(1)] set signal state = 0x8
Jan 3 17:46:29.859: r2_reg_channel_disconnected(0/0/0:0(1))
Jan 3 17:46:29.859: r2_reg_process_event: [0/0/0:0(1), R2_REG_IDLE, E_R2_REG_DISCONNECT(91)]
Jan 3 17:46:29.859: r2_reg_disconnect_idle(0/0/0:0(1))
Jan 3 17:46:29.859: R2 Incoming Voice(0/0): DSX (E1 0/0/0:0): STATE: R2_IN_IDLE R2 Got Event R2_STOP
This is mi conf from the controller e1:
controller E1 0/0/0
framing NO-CRC4
line-termination 75-ohm
ds0-group 0 timeslots 1-15,17-31 type r2-digital r2-compelled ani
cas-custom 0
invert-abcd 0 0 1 1
country telmex
category 2
answer-signal group-b 1
ani-digits min 0 max 10
I've searching for thi error and in some post from cisco, the aswer to solve this was implement this command:
(config)#controller e1 0/0/0
(config-controller)#cas-custom 0
(config-ctrl-cas)#collect-call-enable
But it is not under the CAS custom 0.
vpn(config-controller)#cas-custom 0
gwpitvpn(config-ctrl-cas)#co?
country
vpn(config-ctrl-cas)#collect-call-enable
^
% Invalid input detected at '^' marker.
vpn(config-ctrl-cas)#
show you please help me with my problem?
Mi IOS version is:
flash0:c3900e-universalk9-mz.SPA.151-4.M4.bin
reggards
P.D. This is the link with the answer of the "collect-call-enable" command.
https://supportforums.cisco.com/thread/2127105
