Dear All,
anyone can help me.
its a hardware problem or just not get power to module 1 for module WS-X6748-GE-TX?
this is the capture from show module and sh log :
------------------ show module ------------------
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
1 48 CEF720 48 port 10/100/1000mb Ethernet WS-X6748-GE-TX xxx
5 2 Route Switch Processor 720 (Active) RSP720-3CXL-GE xxx
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
1 0027.0d89.f178 to 0027.0d89.f1a7 3.2 12.2(18r)S1 12.2(33)SRD3 PwrDown
5 001c.584e.a57c to 001c.584e.a57f 5.9 12.2(33r)SRD 12.2(33)SRD3 Ok
Mod Sub-Module Model Serial Hw Status
---- --------------------------- ------------------ ----------- ------- -------
1 Distributed Forwarding Card WS-F6700-DFC3CXL xxxxx 1.6 PwrDown
5 Policy Feature Card 3 7600-PFC3CXL xxxxx 1.1 Ok
5 C7600 MSFC4 Daughterboard 7600-MSFC4 xxxxx 1.4 Ok
Mod Online Diag Status
---- -------------------
1 Not Applicable
5 Pass
show log :
%DIAG-SP-6-RUN_MINIMUM: Module 1: Running Minimal Diagnostics...
%DIAG-SP-3-MAJOR: Module 1: Online Diagnostics detected a Major Error. Please use 'show diagnostic result <target>' to see test results.
%CONST_DIAG-SP-3-BOOTUP_TEST_FAIL: Module 1: TestFibDevices failed
%CONST_DIAG-SP-3-BOOTUP_TEST_FAIL: Module 1: TestIPv4FibShortcut failed
%CONST_DIAG-SP-3-BOOTUP_TEST_FAIL: Module 1: TestNATFibShortcut failed
%CONST_DIAG-SP-3-BOOTUP_TEST_FAIL: Module 1: TestMPLSFibShortcut failed
%CONST_DIAG-SP-3-BOOTUP_TEST_FAIL: Module 1: TestL3VlanMet failed
%HA_EM-6-LOG: tmpsys:/eem_policy/Mandatory.go_bootup.tcl: GOLD EEM TCL policy for boot up diagnostic
%CONST_DIAG-SP-3-BOOTUP_TEST_FAIL: Module 1: TestAclPermit failed
%CONST_DIAG-SP-3-BOOTUP_TEST_FAIL: Module 1: TestQos failed
%CONST_DIAG-SP-3-BOOTUP_TEST_FAIL: Module 1: TestNetflowShortcut failed
%OIR-SP-3-LC_FAILURE: Module 1 has Major online diagnostic failure, Card will be powered down. Please check bootflash diaginfo file for detailed diagnostic result.
%C7600_PWR-SP-4-DISABLED: power to module in slot 1 set off (Diagnostic Failure)
Best Regards,
Budi
