Hi all,
I have 2620XM router. on which I see a virtual-access1 interface. there are no virtual-templates configured on the router neither there is any IP configuration on it. What is the purpose of having such an interface & it seems it was automatically created?
Router#sh ip int brief
Interface IP-Address OK? Method Status Protocol
FastEthernet0/0 10.123.1.1 YES NVRAM up up
Serial0/0 unassigned YES NVRAM up up
Serial0/0.100 <<<IP>>>> YES NVRAM up up
Virtual-Access1 unassigned YES unset up up
Loopback0 <<<<IP>>> YES NVRAM up up
Router#sh int Virtual-Access1
Virtual-Access1 is up, line protocol is up
Hardware is Virtual Access interface
MTU 1492 bytes, BW 100000 Kbit, DLY 100000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Base PPPoE vaccess, loopback not set
DTR is pulsed for 5 seconds on reset
Last input never, output never, output hang never
Last clearing of "show interface" counters 18w0d
Input queue: 0/4096/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Router#sh run int Virtual-Access1
Building configuration...
Current configuration : 61 bytes
!
interface Virtual-Access1
no ip address
ip mtu 1500
end
Thanks in advance
