Hello,
I have some minor experience with Cisco switches but this is the case:
We will create a ring of 8 Catalyst 2960 (layer 2) switches that are connected via optical fiber.
The switches would be connected to each other using trunking on the fiber port.
VTP is not recommended by our supplier.
Now I am wondering, do I need to create every VLAN on every switch in order to make it able to trunk that VLAN?
If I would like a device in VLAN 66 on switch1 and on switch8, do I need to create VLAN 66 then also on switch 2-7?
Thank you.
Best Regards,
Joris
