Hi,
We activated the dual nic of the VCS Expressway by adding an option key on it.
The option key is installed sucessfully and the VCS need to be restarted before the option key will take effect.
After restarting the VCS, we cannot access already the web interface. Before, we can access it via web.
Also checking on the VCS Control traversal client zone, the traversal zone was already in failed mode.
We cannot telnet/SSH the VCS-E box.
The VCS Expressway is not located on the same workstation area and it is located on the remote site so by this time i cannot check the box physically.
What should be checked on the VCS Expressway when i will be visiting on the site?
Thank you for help.
best regards,
Acevirgil
