05-23-2013 11:21 AM - edited 03-16-2019 05:28 PM
Hi all,
I've got an issue with a 7911 that I factory reset.
First, I reset using the 123456789*0# key sequence, then pointed option 150 at my laptop and did a Wireshark capture. It keeps trying to download term06.default.loads, which is a bit odd considering it's a 7911. Screen then changes to Cisco logo with bullseye in lower left corner, and it just sits there.
I then came across another reset key sequence - 3491672850*#, which seemed to reset it again, but now when it boots up the screen is blank and I get exactly the same tftp requests as before this reset, except this time it gets stuck in a boot loop.
Is it a brick or is there a way to recover it? I've tried with term06.default.loads from about half a dozen different firmware versions from 7, 8 and 9. It never asks for any other file as it never gets past the first download. Wireshark capture attached. Using tftpd64 on my laptop.
Thanks in advance,
Jason