Hi Guys,
I need spanning tree port type details network/edge/normal. what comes as default and when to use other port type in network.
how would it behave when VPC is configured.
Switch A Switch B
Switch C ------------------- Switch D
Switch E
Switch A is connected to C and D with trunk ports forming Port channel and L3 interface is configured on same Port channel.
Same way SwitchB is connected with C and D these port channel are part of VPC.
From Switch E which is Access switch forming VPC with C and D.
C and D are agg switches and all VPC config are on it .
C interface facing D is configured with port type network. C and D interfaces facing A and B (L3 device facing ) are port type edge trunk and interfaces n C and D facing E are simply set for default.
Need any doc for deep drive.
Thanks
Ajay
