Dear Folks,
Kindly, suggest the best recommended values for the timers in 802.1x (EAP-TLS)... Should i keep default all or change or some of them?
Also, what do we need reauthentication timers? Any benefit to use it? Does it prompt to users or became invisible? and What are the best values, in case if we need to use it?
Thanks,
Regards,
Mubasher
My Interface Configuration is as below;
---
interface GigabitEthernet1/34
switchport access vlan 131
switchport mode access
switchport voice vlan 195
ip access-group ACL-DEFAULT in
authentication event fail action authorize vlan 131
authentication event server dead action authorize vlan 131
authentication event server alive action reinitialize
authentication open
authentication order dot1x mab
authentication priority dot1x mab
authentication port-control auto
mab
snmp trap mac-notification change added
dot1x pae authenticator
dot1x timeout tx-period 5
storm-control broadcast level 30.00
spanning-tree portfast
spanning-tree bpduguard enable
!
----
