Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,I am having a issue with BGP conditional advertisement using an exist-map.My scenario is as belowR1 connected to ISP1R2 connected to ISP2R1 and R2 have IBGP peeringI have split my /24 prefix into two /25 prefixes for inbound load sharing of t...
I am trying to test MAB using Cisco ISE (2.0.0.306) for Avaya IP Phones connected to a Brocade ICX 7450 switch stack.
I intend to dynamically apply VLAN & ACL settings to the phone.
Although I have the VLAN tag as a numerical value, ISE is still unab...
I am trying to authenticate WLC7.x using TACACS. I have set up my ACS 5.1 (shell profile, access policies) but still unable to login to the WLC using my TACACS+ credentials. I can see the hit count going up in the ACS and can see my login in the pa...
Hi All,I've got an issue when adding a device to ACS.When I try to login to the device after adding it to the ACS, it does'nt prompt me to enter my tacacs username and password, instead it prompts me to enter the tacacs username/password details when...
I tried to a password recovery on Cisco 3750 switch. I followed all the steps and got to the point where I copied the config.text to the running-config. After this I got the privileg exec mode of the switch. When I tried to configure the switch with ...
Hi Ganesh,I am using the MSO to push out the config to the APICs.I have added another DHCP policy as you suggested but it doesn't allow me to attach more than one policy to the BD.Is this option available only on the APIC?
@Cristian Matei wrote:Hi, The config provides both redundancy and load-sharing: - you advertise both /25 prefixes from both of your routers, conditionally based on the existence of 11.11.11.11/32 in BGP table; this allows for redundancy/fa...
Hi Cristian,Thanks a lot for the detailed explanation!Applying your example to my scenario, the conditional prefix is 22.22.22.0/24 instead of 22.22.22.22/32. I have split this into 22.22.22.0/25 & 22.22.22.128/25 and would like advertise them out of...
Hi Cristian,Thanks heaps for your suggestion! I tried as you said & it indeed advertised it after a minute & removed it a minute after shutting down the interface! But as per my post to @Vishaw before, I would also like to filter my internal prefixes...
