Hi,
I have a PoE enabled device connected to our 2960-S switch port Gi 2/0/45 for which I am getting following log continuously.
184581: 045866: Jul 18 09:22:06.305 MUM: %ILPOWER-7-DETECT: Interface Gi2/0/45: Power Device detected: IEEE PD (D_USER_STACK-2-2)
184582: 045867: Jul 18 09:22:07.469 MUM: %ILPOWER-5-IEEE_DISCONNECT: Interface Gi2/0/45: PD removed (D_USER_STACK-2-2)
184583: Jul 18 09:22:08.513 MUM: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet2/0/45, changed state to down
184584: Jul 18 09:22:09.530 MUM: %LINK-3-UPDOWN: Interface GigabitEthernet2/0/45, changed state to down
184585: Jul 18 09:22:10.830 MUM: %PARSER-5-CFGLOG_LOGGEDCMD: User:mman logged command:!exec: enable
184586: Jul 18 09:22:11.790 MUM: %LINK-3-UPDOWN: Interface GigabitEthernet2/0/45, changed state to up
184587: Jul 18 09:22:12.791 MUM: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet2/0/45, changed state to up
This is causing the port to flap continuously.
The device is working on the required ac power supply which can not be removed as device gets powered off completely.
So disabling the PoE capability on the port may solve the issue.
Kindly suggest the steps/commands or any other solution to solve this issue.
Regards.
