Hi,
I have a stack of 4 WS-C3850-24P switches with data and powerstack cables connected. One of the switches has an additional 1100WAC Power Supply in slot B.
When I do a "show env power all" I can see the 5 power supplies:
sh env power all
SW PID Serial# Status Sys Pwr PoE Pwr Watts
-- ------------------ ---------- --------------- ------- ------- -----
1A PWR-C1-715WAC LIT17320CEB OK Good Good 715
1B Not Present
2A PWR-C1-715WAC LIT17320B7Q OK Good Good 715
2B PWR-C1-1100WAC LIT17320QUK OK Good Good 1100
3A PWR-C1-715WAC DCB1734G15J OK Good Good 715
3B Not Present
4A PWR-C1-715WAC DCB1734G14A OK Good Good 715
4B Not Present
When I do a "show power inline", it only shows the 715WAC power supplies in slot A of each stack member:
sh pow inline
Module Available Used Remaining
(Watts) (Watts) (Watts)
------ --------- -------- ---------
1 720.0 190.2 529.8
2 720.0 238.2 481.8
3 720.0 214.2 505.8
4 720.0 132.0 588.0
Any idea how this come ?
