Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We are using DNA-C and recently enabled the email notifications. To our surprise the email title and body that DNA-C sends is not configurable, which is not great. I asked Cisco TAC and it's not a feature they're going to add to DNA-C, it's not ev...
Our AV integrator is installing new Q-SYS audio/video decoder in a large meeting room. They have connected Q-SYS audio/video encoders/decoders (model nv-32-H) to a dedicated 3850 switch connected to the production network. This switch has a data and ...
Hi, I have a stack of 4 WS-C3850-24P switches with data and powerstack cables connected. One of the switches has an additional 1100WAC Power Supply in slot B.When I do a "show env power all" I can see the 5 power supplies:sh env power allSW PID ...
All,We are going to migrate all the servers of our Brussels branch to a remote Data Center based in London.In the meantime we would like to implement a Cisco Call Manager v6 solution with Unity.Are there some restrictions or best practices about havi...
Yes devices (different type, not Q-SYS controller) connected to Gi1/02 and Gi1/0/4 are stable.It's only these Q-SYS devices that are having this problem.SWITCH uptime is 1 week, 5 days, 3 hours, 24 minutes
Same additional checks I have done:SWITCH#sh int gi1/0/3GigabitEthernet1/0/3 is up, line protocol is up (connected)Hardware is Gigabit Ethernet, address is 2852.6171.1003 (bia 2852.6171.1003)Description: MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 us...
It's a good idea to test the cabling but I don't think that's causing it. Only the 5 Q-SYS devices connected to that switch are having problems. The other equipment has a stable network connection. However, here are the test results. Cabling seems fi...
We had the exact same issue today after upgrading a stack of 3 catalyst 9300 switches to iOS-xe 17.6.4Did Cisco TAC found a solution or was the switch RMA’d ?
Hi Folks,This is an old thread but was never resolved.I'm trying the exact same thing and it doesn't workshow run | include hostname | redirect tftp://192.168.0.1/output.txtAny clue how I can display the hostname of the device with a simple show comm...
