Hopefully, this is not a duplicate post, IF so, please direct me to the content that will answer the following situation.
Looking for some information as well as resolution to the following system log messages we are receiving on a Cisco Catalyst 2960x using the current version:
Cisco IOS Software, C2960X Software (C2960X-UNIVERSALK9-M), Version 15.0(2)EX5, RELEASE SOFTWARE (fc1)
%ILPOWER-7-DETECT: Interface Gi1/0/33: Power Device detected: Cisco PD
Mar 23 21:07:33.353: %ILPOWER-5-POWER_GRANTED: Interface Gi1/0/33: Power granted
Mar 23 21:07:33.794: %ILPOWER-5-IEEE_DISCONNECT: Interface Gi1/0/33: PD removed
What little I could find, I am hesitant to do as I am not sure whether this is the rightful answer and while checking out the command was unable to find part of the command available. Below is the link.
https://community.merunetworks.com/merunetworks/topics/aps_connected_to_cisco_poe_switch_are_continuously_powering_on_and_off
Here is the port configuration:
interface GigabitEthernet1/0/33
switchport access vlan 226
switchport mode access
shutdown
end
Yes, I have shut it down at this point only as a precautionary measure.
Lastly, this is in a university apartment/dorm so, have yet to go see what might be connected to the wall jack as it is a remote site.
Any answers/ideas/suggestions would be greatly appreciated!
Thank you.
