Hi,
Does anyone know how to re-run the setup script on a PI2.2 (UCS) appliance after it has been initially executed?
It used to be after a reboot of a server you could type the word 'setup' at the very first login prompt after boot up, but I don't see that option any more.
I tried typing 'setup' at the first login prompt, but its just shows a bad login, rather than running the setup script.
The 'write erase' command is also disabled in 2.2, so I can't use that to start again and force a the setup script to run.
Looks like once you have run setup once, you're stuck with that config? If you want to switch a unit to be a HA secondary, do you have to wipe the box and start again...?
I've checked the user, admin, quick start and command reference guides, but there is no reference about how to run the setup script a second time.
Thanks
Nigel.
