04-27-2015 07:58 AM - edited 03-07-2019 11:45 PM
Hi there,
I am curios about where the "ip nat stateful" command went. We upgraded a Cisco CISCO3945
from
c3900-universalk9-mz.SPA.151-4.M2.bin
to
c3900-universalk9-mz.SPA.154-3.M2.bin
after the reboot, some ip nat commandos are missing like
ip nat inside source static 10.228.2.49 10.89.16.19 vrf POI mapping-id 10
...we conclude that in version 15.4 the ip nat statful command is missing
within this subconfig we could snat with the id 10 as mentioned above.
Unfortunately, the command is not applicable in the new config. However I get a Command Context Auto fulfilment but this command do not made it's way into the running config.
Does anyone know, if this version has problem with snat?
Best Regards,
Robert