01-24-2016 09:19 AM - edited 03-17-2019 05:37 AM
Hi,
we have a CME 10.5 installation with a bunch of 7965G phones. I would like to force them to use G.722 for internal calls,
I tried to configure this on the ephone level, but:
router(config-ephone)#codec g722-64K
The phone/phone load for this device does not support the codec entered, configuration retained, but the voice codec unchanged!
Please also check if (service phone g722CodecSupport 2)
is configured either under telephony-service or ephone-template
as applicable; may need to regenerate cnf files and reset the phone.
Firmware being used: SCCP45.9-4-2-1S
telephony-service
..
service phone g722CodecSupport 2
load 7965 SCCP45.9-4-2-1S.loads
...
Someone any hints?
Thanks!
Heinz