Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I would like to remove certificates on a couple of IOS routers and thought I can quicklie automate this using tcl. The interactive sequence at the CLI would be conf tno crypto pki trustpoint TRUSTPOINTNAME which leads to the message: % Removing a...
Hi,
after an IOS update from version c2960x-universalk9-tar.152-2.E6 to c2960x-universalk9-tar.152-4.E6 we are getting the message
%ILET-1-AUTHENTICATION_FAIL: This Switch may not have been manufactured by Cisco or with Cisco's authorization. Th...
Hi,
does anyone know how to assign a dedicated management VLAN other than BVI1/VLAN1 to a Cisco 2700 series IOS access point?
At the moment we are using the default BVI1, which maps to VLAN1:
interface BVI1 ip address 192.168.0.1 255.255.255.0 no ip...
Hi,
I´ve configured a Cisco 4331 with the Zone Based Firewall (ZBF) features. Everything works fine so far, but when I wanted to take a closer look to the dropped packets I noticed that not all are shown.
I switched it on globally using:
parameter...
Hi,
I would like to use Nagios to monitor certain variables of a CCME router (2951 on IOS 15.4).
According to the following article
http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucme/mib/reference/guide/ccme_mib.html
the MIB CISCO-CCME-MIB ...
Thanks!
I did an snmpwalk from there any found the configuration-related object tree (ccmeConfig), starting with 1.3.6.1.4.1.9.9.439.1.
Seems that they have removed the ccmeActiveStats tree, which started with 1.3.6.1.4.1.9.9.439.0.0 in older versi...
Hi Mohammed,
thanks. I had a look on this, but it isn´t working either.
When I try to probe one of the listed OIDs it says:
./check_snmp -H 192.168.1.1 -C readcom -o 1.3.6.1.4.1.9.12.5.2External command error: Error in packetReason: (noSuchName) T...
Hi Manish,
thanks!
I did a downgrade of the IOS to 154-3.M6a, where it´s working as expected.
It seems to be changed from 15.5 onwards.
I don´t think that´s a config related issue; it´s just a simple CfwdAll to another DN - which in 15.5 and 15.6...
