12-18-2015 02:03 PM
I am running CNA 6.2 and am trying to add a WS-C2960S-24PS-L switch to an existing Community. Every time I try to add the switch I get "Authentication Failure".
I can bring up the switch just fine on its own in CNA and fully configure it, but I cannot join it to my existing Community. What am I doing wrong? I have VTP mode set to transparent on the new switch and have manually configured the management VLAN on it and assigned an IP. I have it plugged into a current community-member switch
Thanks in advance.
Solved! Go to Solution.