06-30-2016 07:41 AM - edited 03-21-2019 10:34 AM
My ATA is not registering with the PBX system. If I setup a softphone I can get it to register without any issues. The issue seems to be with the ATA specifically. I am running FreePBX ver 13.x (PBXinaFlash) for Raspberry Pi 2. My ATA is running Firmware ver 1.4.1 and has been reset to factory defaults with the exception of the line I am trying to register. I made sure the extension number, ports and secret matched on both the ATA and PBX settings. My proxy is set to that of the PBX using IP address not hostname or FQDN.
I turned on logging and captured the following after power cycling the ATA and seeing the status change from "not registered" to "failed"
Jun 29 20:45:56 SPA112 user.notice sprvoip: cmd 5, EP 2, ParameterType 22, ParameterValue 1
Jun 29 20:45:56 SPA112 user.notice sprvoip: cmd - 5, response 8
Jun 29 20:45:56 SPA112 user.notice sprvoip: cmd 5, EP 2, ParameterType 27, ParameterValue 60
Jun 29 20:45:56 SPA112 user.notice sprvoip: cmd 5, EP 2, ParameterType 26, ParameterValue 70
Jun 29 20:45:56 SPA112 user.notice sprvoip: cmd - 5, response 8
Jun 29 20:45:56 SPA112 user.notice sprvoip: cmd - 5, response 8
Jun 29 20:45:56 SPA112 user.notice sprvoip: cmd 5, EP 1, ParameterType 22, ParameterValue 1
Jun 29 20:45:56 SPA112 user.notice sprvoip: cmd - 5, response 8
Jun 29 20:45:56 SPA112 user.notice sprvoip: cmd 5, EP 1, ParameterType 27, ParameterValue 60
Jun 29 20:45:56 SPA112 user.notice sprvoip: cmd 5, EP 1, ParameterType 26, ParameterValue 70
Jun 29 20:45:56 SPA112 user.notice sprvoip: cmd - 5, response 8
Jun 29 20:45:56 SPA112 user.notice sprvoip: cmd - 5, response 8
Jun 29 20:46:15 SPA112 user.notice sprvoip: cmd - 18, response 23
Jun 29 20:46:16 SPA112 user.notice sprvoip: cmd - 18, response 49
Can anyone tell me what these response codes mean? Is there something else I should check?
Thanks for your assistance.