Hi All,
Cisco AP 2802I-E-K9, AP Running Image 8.2.130.0, Couldn't joint with WLC-2504 software version 8-2-130-0.But AIR-CAP2702I-E-K9 can register with WLC and working fine. getting below error from the AP2802I
[*10/18/2016 11:01:43.6373] CAPWAP State: Discovery
[*10/18/2016 11:01:43.6390] Discovery Request sent to 255.255.255.255 with disco very type set to CAPWAP_DISCOVERY_TYPE_UNKNOWN(0)
[*10/18/2016 11:01:43.6398] Discovery Response from 10.10.10.5
[*10/18/2016 11:01:53.0000] CAPWAP State: DTLS Setup
[*10/18/2016 11:01:54.6368] CAPWAP State: Join
[*10/18/2016 11:01:54.6379] Sending Join request to 10.10.10.5 through port 5256
[*10/18/2016 11:01:59.2746] Join Response from 10.10.10.5
[*10/18/2016 11:01:59.2747] CAPWAP State: Image Data
[*10/18/2016 11:01:59.2748] CAPWAP State: Configure
[*10/18/2016 11:01:59.3049] DTLS: packet too old or a replay distance=0, this_se q_num=1, last_seq_num=1
[*10/18/2016 11:02:44.8852] GOING BACK TO DISCOVER MODE
[*10/18/2016 11:02:44.8855] CAPWAP State: DTLS Teardown
[*10/18/2016 11:02:49.6374] CAPWAP State: Discovery
[*10/18/2016 11:02:49.6454] Discovery Request sent to 255.255.255.255 with disco very type set to CAPWAP_DISCOVERY_TYPE_UNKNOWN(0)
[*10/18/2016 11:02:49.6463] Discovery Response from 10.10.10.5
[*10/18/2016 11:02:59.0000] CAPWAP State: DTLS Setup
[*10/18/2016 11:03:00.6204] CAPWAP State: Join
[*10/18/2016 11:03:00.6215] Sending Join request to 10.10.10.5 through port 5256
[*10/18/2016 11:03:05.2748] Join Response from 10.10.10.5
[*10/18/2016 11:03:05.2748] CAPWAP State: Image Data
[*10/18/2016 11:03:05.2749] CAPWAP State: Configure
[*10/18/2016 11:03:05.3029] DTLS: packet too old or a replay distance=0, this_se q_num=1, last_seq_num=1
Keep getting the same error. This is new installation and doesn't have Service contract witch Cisco.
Please advice
Thanks
Mohamed Nazar
