08-29-2016 07:43 AM - edited 07-05-2021 05:44 AM
Hi all,
I´m testing with a Cisco WLC 2504 and some 1832 APs. I have configure a DHCP Scope on interface 2 of the controller with
a lot of different configurations but the DHCP is not running and the Access Point don´t get an IP address. My first question: Is it possible to make DHCP for Access Points or only for Wireless clients?
These are my interfaces:
AP-Manager Interface:
My DHCP Scope:
Advanced DHCP:
Have I overlooked something? Is there someone uses dhcp for its access points?
Thank you!
Solved! Go to Solution.