Hi all,
I'm trying to edit an access-list, but I experience some problems.
I'm making the following changes:
1. Delete access-list 1
2. Install the commands below
access-list 1 remark == s1
access-list 1 permit ip address 1
access-list 1 remark ==> Network Management <==
access-list 1 remark == s2
access-list 1 permit ip address 2
access-list 1 permit ip address 3
access-list 1 remark == s3
access-list 1 permit ip address 4
access-list 1 remark ==> Scanning Appliances <==
access-list 1 remark == s4
access-list 1 permit ip address 5
access-list 1 permit ip address 6
access-list 1 remark == s5
access-list 1 permit ip address 7
access-list 1 permit ip address 8
access-list 1 permit ip address 9
access-list 1 remark == s6
access-list 1 permit ip address 10
access-list 1 permit ip address 11
access-list 1 permit ip address 12
access-list 1 remark == s7
access-list 1 permit ip address 13
access-list 1 permit ip address 14
access-list 1 permit ip address 15
access-list 1 permit ip address 16
access-list 1 remark == s8
access-list 1 permit ip address 17
access-list 1 permit ip address 18
access-list 1 remark == s9
access-list 1 permit ip address 19
access-list 1 deny any log
3. After issueing show running-config | include access-list 1, I receive this:
access-list 1 remark == s1
access-list 1 permit ip address 1
access-list 1 remark ==> Network Management <==
access-list 1 remark == s2
access-list 1 permit ip address 2
access-list 1 permit ip address 3
access-list 1 remark ==> Scanning Appliances <==
access-list 1 remark == s3
access-list 1 permit ip address 5
access-list 1 remark == s4
access-list 1 permit ip address 4
access-list 1 permit ip address 6
access-list 1 remark == s5
access-list 1 permit ip address 7
access-list 1 permit ip address 8
access-list 1 permit ip address 9
access-list 1 remark == s6
access-list 1 permit ip address 10
access-list 1 permit ip address 11
access-list 1 permit ip address 12
access-list 1 remark == s7
access-list 1 permit ip address 13
access-list 1 permit ip address 14
access-list 1 permit ip address 15
access-list 1 permit ip address 16
access-list 1 remark == s8
access-list 1 permit ip address 17
access-list 1 permit ip address 18
access-list 1 remark == s9
access-list 1 permit ip address 19
access-list 1 deny any log
What is going on here? How can I fix this? I noticed more engineers experience difficulties with these issues.
