Hi
I've recently replaced an 1801 with an ISR4331. I previously had a PPTP VPN set up for occasional remote access to a server inside the network while not at the site from laptops or mobile phones. I have copied the config across to the new router and while the VPN will establish I'm unable to send any traffic across it.
vpdn enable
!
vpdn-group pptpvpn
! Default L2TP VPDN group
! Default PPTP VPDN group
accept-dialin
protocol any
virtual-template 10
interface Loopback4
ip address 10.0.2.129 255.255.255.255
ip local pool VPN-POOL 10.0.2.130 10.0.2.142
interface Virtual-Template10
ip unnumbered Loopback4
zone-member security inside
peer default ip address pool VPN-POOL
no keepalive
ppp encrypt mppe auto required
ppp authentication chap ms-chap-v2 VPN-Auth
After some searching I can see suggestions that PPTP is not supported on the ISR 4K, I am also getting the following error during set-up.
%FMANRP_ESS-4-FULLVAI: Session creation failed due to Full Virtual-Access Interfaces not being supported. Check that all applied Virtual-Template and RADIUS features support Virtual-Access sub-interfaces.
I am not really looking for a super secure/complex solution involving 3rd party applications, have I missed something obvious or do I need to look for an alternative?
Thanks
Paul
