02-06-2018 02:03 PM - edited 03-05-2019 09:52 AM
Hello
is it possible to configure ports on CISCO891-K9 for port-security?
i need to use mac address port-security on few switch ports but "switchport port-security" command is not available.
I am running following:
Cisco IOS Software, C890 Software (C890-UNIVERSALK9-M), Version 15.4(3)M3, RELEASE SOFTWARE (fc2)
ROM: System Bootstrap, Version 12.4(22r)YB3, RELEASE SOFTWARE (fc1)
ROUTER-NAME uptime is 12 weeks, 5 days, 5 hours, 29 minutes
System returned to ROM by power-on
System restarted at 08:23:38 pst Thu Nov 9 2017
System image file is "flash:c890-universalk9-mz.154-3.M3.bin"
Last reload type: Normal Reload
Last reload reason: power-on
\
9 FastEthernet interfaces
1 Gigabit Ethernet interface
1 Serial interface
1 terminal line
1 Virtual Private Network (VPN) Module
256K bytes of non-volatile configuration memory.
247464K bytes of ATA CompactFlash (Read/Write)
License Info:
License UDI:
-------------------------------------------------
Device# PID SN
-------------------------------------------------
*1 CISCO891-K9
Apprecaite responses.
Solved! Go to Solution.