01-10-2018 04:11 AM - last edited on 03-25-2019 04:46 PM by ciscomoderator
Dear All,
We have purchased new Cat 4500 X series switches, we are getting below error
NO SUPPORTED POWER SUPPLIES DETECTED ON LOCAL SUPERVISOR SUPERVISOR WILL BE POWERED DOWN!!!!
Pls fidn the BOM attached, As per the data sheet Power supply seems ok, Can someone let us know way forward
=~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2018.01.10 15:30:16 =~=~=~=~=~=~=~=~=~=~=~=
þ
Rommon (G) Signature verification PASSED
Rommon (P) Signature verification PASSED
FPGA (P) Signature verification PASSED
************************************************************
* *
* Welcome to Rom Monitor for WS-C4500X-16 System. *
* Copyright (c) 2008-2014 by Cisco Systems, Inc. *
* All rights reserved. *
* *
************************************************************
Rom Monitor (P) Version 15.0(1r)SG12
CPU Rev: 2.2, Board Rev: 9, Board Type: 108
CPLD Mobat Rev: 3.0x74b8.0x01db
Chassis: WS-C4500X-16
MAC Address : 00-5d-73-5e-4e-bf
Ip Address : Not set.
Netmask : Not set.
Gateway : Not set.
TftpServer : Not set.
Non-Redundant system or peer not running IOS
System Uplinks & Linecards have been reset!!
***** The system will autoboot in 5 seconds *****
Type control-C to prevent autobooting.
******** The system will autoboot now ********
config-register = 0x2101
Autobooting using the first file from bootflash.....
Loading image !!!!!!!!!!!!!!!
Checking digital signature....
[bootflash:/cat4500e-universalk9.SPA.03.03.02.SG.151-1.SG2.bin]
Digitally Signed Release Software with key version A
Rommon reg: 0x00084F80
Reset2Reg: 0x00004F00
Image load status: 0x00000000
####
Radtrooper 065 Controller 0x13000070..0x1319BC0A Size:0x00661EDC Program Done!
##############
Linux version 2.6.24.4.12.3.k10 (nburra@build-lnx-036) (gcc version 4.2.1 p6 (Cisco c4.2.1-p6)) #1 SMP Tue Oct 23 23:24:25 PDT 2012
Starting System Services
diagsk10-post version 5.1.4.0
prod: WS-C4500X-16 part: 73-14786-07 serial: JAE21430ERC
Power-on-self-test for Module 1: WS-C4500X-16
CPU Subsystem Tests ...
seeprom: Pass
Traffic: L3 Loopback ...
Test Results: Pass
Traffic: L2 Loopback ...
Test Results: Pass
post done
Exiting to ios...
Starting IOS Services
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco IOS Software, IOS-XE Software, Catalyst 4500 L3 Switch Software (cat4500e-UNIVERSALK9-M), Version 03.03.02.SG RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2012 by Cisco Systems, Inc.
Compiled Tue 23-Oct-12 23:51 by prod_rel_team
***********************************************************************
!!!! NO SUPPORTED POWER SUPPLIES DETECTED ON LOCAL SUPERVISOR SUPERVISOR WILL BE POWERED DOWN!!!!
***********************************************************************
Powering down in 10 seconds...
10 09 08 07 06 05 04 03 02 01 00