Hi,
We have bought some Cisco 3802 Ap's. I connected 1 of the AP's to a switch we have at our office to see if it worked and it did. I read that there has been some bugs with the AP where if you connect it to a 100mbps port it will show you the "aptrace_register_sysproc_fn: duplicate registeration for 'wired'".
I have now set up the antenna up on the right location, but we are using a POE which is 1gbps.
The problem is the same as with 100mbps... I have tried to google it, but so far I don't see any solution.
The WLC is running version 8.5.135.0 which is not the newest. I would love to update the version, but we can't since we also have 1602 AP's in our enviroment, so if we update 1 more version it doesn't support it anymore.
Does anyone have a good solution to make the 3802 AP to work with a POE?
Regards,
Jørgen
