When specifying a file path for our config archive, the standby and member switches reboot. While the active switch stays up, the other switches in the stack reboot as soon as the command is entered. If the command is not removed before the switches complete their reboot sequence, they boot into ROMmon.
Is this expected behavior, config issue or bug? Any help is greatly appreciated. Thanks!
Hardware and versions of tested stacks.
Bootloader: 16.12.2r
IOS:16.12.2 and 16.9.4
9300-48A-UXM
9300-48A-P
Here are the commands entered:
(config)# archive
(config-archive)# path flash:/Netops/Rollback/
Prior to entering the commands:
Switch# Role Mac Address Priority Version State
-------------------------------------------------------------------------------------
*1 Active XXXX.XXXX.XXXX 15 V02 Ready
2 Standby XXXX.XXXX.XXXX 5 V02 Ready
3 Member XXXX.XXXX.XXXX 1 V02 Ready
Immediately After:
Labs-1FL-SS#sh switch
Switch/Stack Mac Address : XXXX.XXXX.XXXX - Local Mac Address
Mac persistency wait time: Indefinite
H/W Current
Switch# Role Mac Address Priority Version State
-------------------------------------------------------------------------------------
*1 Active XXXX.XXXX.XXXX 15 V02 Ready
2 Member 0000.0000.0000 0 V02 Removed
3 Member 0000.0000.0000 0 V02 Removed
