Hi
We have a Cisco 3504 controller with 2 catalyst 11ax 9115 AP's in the setup
When I updated cisco 3504 controller to 8.10.122.0 software version, only one AP is coming up and the other AP is giving issues as below
Can you please help
No valid user found, please configure a valid user from Controller[
MDIO Error: MDIO got failure status on phy 6
[*07/15/2020 15:54:58.3330] SYS-COND: AP is in good condition
[07/15/2020 15:55:13.7820] MDIO Error: MDIO got failure status on phy 6
[07/15/2020 15:55:13.8510] MDIO Error: MDIO got failure status on phy 6
[07/15/2020 15:55:13.9270] MDIO Error: MDIO got failure status on phy 6
[07/15/2020 15:55:14.0030] MDIO Error: MDIO got failure status on phy 6
[*07/15/2020 15:55:23.4360]
[*07/15/2020 15:55:23.4360] USB Device Disconnected from the AP
[*07/15/2020 15:55:23.4360]
[07/15/2020 15:57:13.0860] MDIO Error: MDIO got failure status on phy 6
[07/15/2020 15:57:13.1550] MDIO Error: MDIO got failure status on phy 6
[07/15/2020 15:57:13.2310] MDIO Error: MDIO got failure status on phy 6
[07/15/2020 15:57:13.3070] MDIO Error: MDIO got failure status on phy 6
[07/15/2020 15:59:12.3900] MDIO Error: MDIO got failure status on phy 6
[07/15/2020 15:59:12.4590] MDIO Error: MDIO got failure status on phy 6
[07/15/2020 15:59:12.5350] MDIO Error: MDIO got failure status on phy 6
[07/15/2020 15:59:12.6110] MDIO Error: MDIO got failure status on phy 6
% Authentication failed
No valid user found, please configure a valid user from Controller
