I am converting lightweight AP to mobility express mode but not success. please look below detail and suggest.
I required a standalone AP for my organization, so we have purchased AIR-AP2802I-D-K9 AP.
So first time I logged in AP by console and checked show version. got below output.
cisco AIR-AP2802I-D-K9 ARMv7 Processor rev 1 (v7l) with 1030580/712868K bytes of memory.
Processor board ID JIN2220B02F
AP Running Image : 8.2.151.0
Primary Boot Image : 8.2.151.0
Backup Boot Image : 0.0.0.0
2 Gigabit Ethernet interfaces
2 802.11 Radios
Radio Driver version : 9.0.5.5-W8964
Radio FW version : 9.1.8.1
NSS FW version :
Base ethernet MAC Address : 00:5D:73:AF:B9:AC
then I have follow below instruction link to convert Lightweight AP to Mobility Express mode.
https://www.semfionetworks.com/blog/convert-a-cisco-capwap-ap-to-a-mobility-express-ap
As instructed first upgrade 8.2 to higher version so i have upgraded to 8.5 then conver to mobility express with below command.
After running this command
AP00XD.7XAF.XXXX#ap-type mobility-express tftp://10.106.132.93/AIR-AP2800-K9-ME-8-10-142-0.tar
got below output
Starting the ME image download...
It may take a few minutes to finish download.
If it is longer, please abort command, check network connection and try again
######################################################################## 100.0%
Image transfer complete.
Image downloaded, writing to flash...
do CHECK_ME, part2 is active part
Image signing verify success.
[5/18/2018 4:2:53] Master now upgradedMaster now upgradedupgrade.sh: part to upgrade is part1
tar: write error: No space left on device
upgrade.sh: Command "tar -xf /tmp/part.tar -C /bootpart/part1" failed.
upgrade.sh: df /bootpart/part1
upgrade.sh: du -h /bootpart/part1
upgrade.sh: Writing image to disk...
sh: 1K-blocks: unknown operand
upgrade.sh: activate part1, set BOOT to part1
upgrade.sh: AP primary version: 8.10.142.0
Archive done.
AP00XD.7XAF.XXXX#reload
Proceed with reload? [confirm] y
After reload showing same old version and not a mobility express
cisco AIR-AP2802I-D-K9 ARMv7 Processor rev 1 (v7l) with 1028528/655216K bytes of memory.
Processor board ID JIN2220B02F
AP Running Image : 8.5.105.0
Primary Boot Image : 8.5.105.0
Backup Boot Image : 0.0.0.0
2 Gigabit Ethernet interfaces
2 802.11 Radios
Radio Driver version : 9.0.5.5-W8964
Radio FW version : 9.1.8.1
NSS FW version : 2.4.18
