10-28-2022 09:09 AM
I boot up a new cisco Access Point C9115AXI , but i'm getting some errors in logs like this :
| | | |/ __| / __|/ _ \
| |___ | |\__ \| (__| (_) |
\____||_||___/ \___|\___/
_ _ ____ _
| | | | | __ ) ___ ___ | |_
| | | |___| _ \ / _ \ / _ \| __|
| |_| |___| |_) | (_) | (_) | |_
\___/ |____/ \___/ \___/ \__|
U-Boot 2017.09 (May 21 2020 - 19:22:05 -0700) Broadcom BCM49408
Board: SS-i
I2C: ready
DRAM: 2 GiB
enable MMU ... OK
NAND: Status wait timeout: nandsts=0x0 mask=0x40000000, count=0
NAND ECC BCH-8, page size 4096 bytes, spare size used 216 bytes
1024 MiB
MMC:
SF: Detected mx25l6405d with page size 256 Bytes, erase size 4 KiB, total 8 MiB
In: serial
Out: serial
Err: serial
Platform: 4908
SF: Detected mx25l6405d with page size 256 Bytes, erase size 4 KiB, total 8 MiB
saved CRC ffffffff doesn't = calc CRC 997e20e8
*** Board is not initialized properly ***
Uncorrectable ECC Error: intr 0x50, addr=0x0, blk=0,
Uncorrectable ECC Error: intr 0x50, addr=0x1000, blk=0,
Uncorrectable ECC Error: intr 0x50, addr=0x2000, blk=0,
Uncorrectable ECC Error: intr 0x50, addr=0x3000, blk=0,
Uncorrectable ECC Error: intr 0x50, addr=0x4000, blk=0,
Uncorrectable ECC Error: intr 0x50, addr=0x5000, blk=0,
Uncorrectable ECC Error: intr 0x50, addr=0x6000, blk=0,
Uncorrectable ECC Error: intr 0x50, addr=0x7000, blk=0,
Uncorrectable ECC Error: intr 0x50, addr=0x8000, blk=0,
Uncorrectable ECC Error: intr 0x50, addr=0x9000, blk=0,
Uncorrectable ECC Error: intr 0x50, addr=0xa000, blk=0,
see the full logs in the attached file