Hello all, Maybe someone can help me. We have several nexus N5k in use all with version 7.3. When I look at different trunk port channels I can see jumbo packets everywhere. But the MTU is not higher than 1500 on any of the interfaces. Also in the Config I don't find MTU adjustments anywhere. I know that with the N5k series the setting is controlled by a policy and that the actual setting is shown with the command sh queuing... but even here 1500 is set. I can find several Cisco community posts about this. Many have the same phenomenon but no one can answer it. Maybe one of you can. Why are "jumbo packets" (L3???) displayed where there are none. Also with trunks to another switch jumbos are shown, but the other switch has my giants or errors.
