I'm connecting an handset to an E&M 4 wire interface via LMR VOIP to radios with E1 interface.
The radios are either TX or RX. As such I need to separate the E&M RX and TX trunks which will eventually end up to different E1 timeslots.
The "connection trunk xxx" command seems to start a full duplex trunk. Is there some way to separate the Rx and Tx trunks for E&M and E1 CAS interfaces to different destinations? E.g. equivalent of a command option like
voice-port 0/1/0
connection trunk 1111 receive
connection trunk 2222 transmit
Magnus
