I'm connecting an handset to an E&M 4 wire interface via LMR VOIP to radios with E1 interface.The radios are either TX or RX. As such I need to separate the E&M RX and TX trunks which will eventually end up to different E1 timeslots.The "connection t...
I would like to have the vWLC management and "APmanager" functionality on separate VLANs. For security reasons I don't like exposing the manager IP to all places where I place APs. But when I disable DYNAMIC-AP-MGMT on the management if and enable it...
I would like to have the vWLC management and "APmanager" functionality on separate VLANs. For security reasons I don't like exposing the manager IP to all places where I place APs. But when I disable DYNAMIC-AP-MGMT on the management if and enable it...
Does anyone know where the 1000Base-ZX specification comes from. I can find the -SX and -LX definitions in the IEEE 802.3 standard, but I can not find any references to the origin of 1000Base-ZX or 1000BASE-LH.
Hi Nithin, There is a specific handset used with a Push To Talk button connected to the E&M port on one side.Like this: |E1------> TX RADIO|HANDSET WITH PTT| <--> |E&M to VOIP| <-----> |VOIP...
I have the PDF file 802.3-2002.pdf from IEEE, but there is no single occurrence of the character combination "zx" anywhere in the 1538 page document. -SX and -LX is defined in there however.
"DCD-Up, DSR-UP, DTR-Down, RTS-Down, CTS-Up"To me these signals indicate:Modems is ready to accept data, but router is not saying it wants to send any, because it is keeping the "Data Terminal Ready" and "Request to Send" down. Have you checked so th...
You can not run framed E1 in one end and unframed E1 in the other. Router A expects a sync channel where router B sends data so you will probably see an E1 out of sync error in router A. Incoming data to router B is corrupted by the sync channel so y...
You can not load a full BGP table of the entire internet with 32MB but you can use the primary connection as default exit point and keep a few of the most significant incoming routes from the secondary peer. E.g. an AS path filter to accept routes wi...