Routers - Small Business

I just set up my new rv 082 and am following the steps for registration.1. the link to register the product www.linksys.com/registration does not exist2. in the pulldown menu in the home products the model does not appear.3. there is no option to reg...

Hi,I would like to foward *::20 and  *:21 from one of my RV082 to a Second one.My configuration :Each RV082 is loadbalanced on each other. Sometime just one (receive the fowarded port)RV082 (1) -> manufactured in 2005- Firmware Version: 2.0.0.19-tm -...

Hi everyone,I got a RV016 with the lastest firmware. We are sharing our office with another business. For the moment we all got everything separate. But since we have two different ISP and both businesses rely on the internet for communication (VOIP)...

I have a RVS4000 router and have connected each of the users to the router via QuickVPN connections.We play the Age Of Empires III game fine when only 1 is connected via QuickVPN.Whenever I have more than 1 connected via QuickVPN, only the 1st user t...

I have a Cisco RV082 Dual WAN router with the latest (only available) firmware 2.0.0.19-tm.I have it set up in Smart Link Backup mode, the primary WAN1 connection is a 12/2mbit Cable connection (DHCP), while backup WAN2 is 6/1mbit DSL connection (PPP...

Hi,I have a problem with my RV042. It is connected with two VPN to a client and to an other site of my company.Sometimes, I can't connect to remote ressources or even ping the remote server behind the remote firewall and if i check the VPN status on ...

I have a UC-560 that I got three remote sites off of. Need to set up VPN between UC560 and SR-520 for voice and data. Also have a SA 520 at the uc560 and a forth site that has a SR520 that is going to use MPLS.I think I have the product to do it.Site...

I have connected a comcast modem that gives me 11mbs download, but when connected to the RV042 as my router, i only have 1.4mbs download. I have download the new version and still download mbs still stayed the same. what can i do?

Has anyone had any luck establishing a VPN tunnel between the RVS4000  and a Juniper Netscreen?  if so, could you please post your configuration?  I've been trying for days to get this to work and I'm starting to think it's impossible.

I have DHCP enabled yet it is not responding to any DHCP requests.Most of our clients have static addresses, but we did set the RV082 up to assign a few addresses for when we have visitors.Am I missing a setting?Paul

Good Afternoon Anyone,Can anyone assist me in setting up VPN on SRP 572?The spec states that it supports 5 VPN tunnels and I just want to setup 2 possible 3.Any advise would be very grateful.Many Thanks in advanceMartin

Having some issues with these 2 equipments.There's an 8 port switch attached after the router so as to support more devices.Basically using 4 SPA2102 is OK. Can make in/out calls from the 4 IADs.However, when the 5th one comes in, all won't work.All ...

I have an RVS4000 which has the latest firmware V1.3.2.0 and the QuickVPN client 1.4.1.2 on a Windows 7 Home Premium X64 laptop.  I can successfully connect the VPN tunnel and ping the internal (Inside) router IP address.  However I cannot ping or us...