Cant See VG 224 Booting Process

[mundheashish]

Dear All,

Please help me out for this

i have one VG224 Router for which i forget password so to rest password i power off and power on it to enter in rommon mode by pressing Ctrl+Break.

But when i power on it it didn't show booting process and directly go on ROUTER> mode after 2-3 min from power on.

its booting process is not visible, even if i press Ctrl+break it didn't show me rommon mode,

so how should i solve this problem??

Regards

Ashish Mundhe

[Charles Hill]

Hello ashish,

below are break key combinations.  Have you successfully used Ctrl break on other devices?

Standard Break Key Combinations

Software	Platform	Operating System	Try This
Hyperterminal	IBM Compatible	Windows XP	Ctrl-Break
Hyperterminal	IBM Compatible	Windows 2000	Ctrl-Break
Hyperterminal	IBM Compatible	Windows 98	Ctrl-Break
Hyperterminal (version 595160)	IBM Compatible	Windows 95	Ctrl-F6-Break
Kermit	Sun Workstation	UNIX	Ctrl-\l
			Ctrl-\b
MicroPhone Pro	IBM Compatible	Windows	Ctrl-Break
Minicom	IBM Compatible	Linux	Ctrl-a f
ProComm Plus	IBM Compatible	DOS or Windows	Alt-b
SecureCRT	IBM Compatible	Windows	Ctrl-Break
Telix	IBM Compatible	DOS	Ctrl-End
Telnet	N/A	N/A	Ctrl-], then type send brk
Telnet to Cisco	IBM Compatible	N/A	Ctrl-]
Teraterm	IBM Compatible	Windows	Alt-b
Terminal	IBM Compatible	Windows	Break
			Ctrl-Break
Tip	Sun Workstation	UNIX	Ctrl-], then Break or Ctrl-c
			~#
VT 100 Emulation	Data General	N/A	F16
Windows NT	IBM Compatible	Windows	Break-F5
			Shift-F5
			Shift-6 Shift-4 Shift-b (^$B)
Z-TERMINAL	Mac	Apple	Command-b
N/A	Break-Out Box	N/A	Connect pin 2 (X-mit) to +V for half a second
	Cisco to aux port	N/A	Control-Shft-6, then b
	IBM Compatible	N/A

see link below(using rommon mode)

http://www.cisco.com/c/en/us/td/docs/routers/access/vg224/software/configuration/guide/scg/scgappc.html