03-21-2015 06:50 AM
Please do help to take a look at my attached screenshot.
My PC at home is around connected to the RV-130W in my company but I can't seem to be able to ping any of the servers inside my company's network.
My home network is 192.168.31.0/24
My company network is 192.168.0.0/24
I am very puzzled why the GreenBow VPN client on my PC doesn't get a DHCP IP address from the RV-130W and it just self-assigned itself an IP address of 10.10.10.10 when the tunnel is open instead which doesn't make any sense to me.
Any help and advice will be greatly appreciated.
03-21-2015 09:15 AM
Please take a look at the routing table on my home PC.
Apparently the GreenBow VPN client added a route of 192.168.0.0 /24 (my office network) to 10.10.10.1 but I didn't configure any 10.10.10.0 network inside my Cisco RV-130W router at all.
Can someone please kindly guide me on how should I configure the IPsec VPN server inside the RV-130W router ?
03-21-2015 09:16 PM
Hi Yatim ,
I am also a Cisco RV130W end user.
I suggest you change your greenbow setting as below and try again .
And I can confirm that greenbow version 5.1 is not compatible with RV130W, for fix that problem, you must use version 6.2 or newer .
I wish the information can help you to fix the problem.
03-22-2015 11:30 PM
Hi Seito,
I am using the GreenBow VPN client version 6.2 now
I have changed the settings to the same as in your screenshot but it is still not working.
User authentication is ok and tunnel is open but I still can't ping my router at 192.168.0.1 and my server at 192.168.0.88
I still see the route of 192.168.0.0 255.255.255.0 to gateway 10.10.10.1 being added into my PC's routing table when the tunnel is open but I can't seem to ping 10.10.10.1 from my PC too.
Do I need to configure routing for network 10.10.10.0/24 inside my RV130W or do I need to configure NAT traversal for 10.10.10.0/24 network to 192.168.0.0/24 network inside my router instead ?
Can I configure the GreenBow VPN client to get an IP address of 192.168.0.XX from the DHCP server inside RV130W instead of using 10.10.10.10 ?
03-24-2015 09:17 AM
I have got the same problem when I have tick the " disable split tunneling" , try to untick it and restart greenbow.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide