09-26-2017 11:38 PM - edited 03-21-2019 10:55 AM
I have purchased the new router RV042 but whe i started this DIAG LED is Always ON, Can't Access the the router. Please Give solutions
09-27-2017 08:03 AM
Hello,
When the diag light is always on (I guess red color) you need to do a hard reset to the router, please follo these steps:
1. With the router connected to the power cord (only power cord no Ethernet cable), clic the reset button for 30 seconds.
2. After those 30 sec, remove the power cord from the router for another 30 sec, very important keep pressing the reset button always.
3. after that min plug back in the power cord to the router for another 30 sec, ALWAYS holding the reset button.
4. after that minute and a half realease the reset button wait for 1 min and do a power cycle, (unplug the power cord form the router for 5 seconds without presing the reset button and plug back in)
Hope this can help
Thank you
03-23-2020 10:38 AM
After completing reset, still got diag blinking... I replaced power supply and it worked. thx
02-27-2021 10:37 PM
Hi Dror ,
Thank you so much. Same issue with me(RV042) - using old power adapter System (green) Diag (yellow ) lights were on, other lights were mildly blinking. Multiple router reset failed ( I should have not done it , should have tried changing adapter first ). Was about to discard the router.
Never imagined it would be power issue as System lights were always on !
Then i tried another adapter (for test) ! It worked !!! Will be buying a new power adapter soon !
Thanks a tonn !
Regards,
01-11-2019 07:09 AM
I had this same problem. I purchased a new identical unit and it had the same problem. I had reused the power supply and when I tried the new power supply the old unit booted right up. So if you have this problem, before replacing see if you can find a different power supply to try - 12V at 1A. Luckily the vendor took the new unit back.
02-19-2019 04:54 AM
I've the same problem! Help Please
02-19-2019 08:42 AM
I highly recommend checking the power supply by trying a different one before replacing the unit.
05-28-2019 10:59 AM
Was going nuts trying to figure out why my RV320 router suddenly was inaccessible...lo and behold, bad power supply. Since the unit was powering on and lights were lighting up, I never would have thought to try a different power supply until reading your post, but after swapping it out it's working fine again -thanks!
03-23-2020 10:03 AM
following reset instruction and a new power supply resolved the diag issue. thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide