help with rv082

[albertldee]

i have the RV082 v03 i set it for load balancing i have 2 8gb Adsl modem connected to Wan1 and Wan2

Question how can i assign a certain pc to use the connecton on Wan2, what i would like is to assign a specific pc on the network to wan2 

[Te-Kai Liu]

Look for the protocol binding settings under System Management>Dual WAN>Edit WAN2.

With a ptotocol binding rule, you can bind all traffic originating from a given IP address to WAN2.      

[jurodri3]

Hello Alber Idee,

Let me share with you some information found on the guide me section about protocol biding configuration step by step.

I hope this information helps you.

http://sbkb.cisco.com/CiscoSB/ukp.aspx?vw=1&docid=69b1889ee61d42bb9a389bf69fb7bf28_Priority_Bandwidth_magement_using_Rv042.xml&pid=4&fcid=&fpid=&slnid=3

If this answer was satisfactory for you, please mark the question as Answered.

Diego Rodriguez

Cisco network engineer

Thank you