11-05-2012 05:53 PM
i have the RV082 v03 i set it for load balancing i have 2 8gb Adsl modem connected to Wan1 and Wan2
Question how can i assign a certain pc to use the connecton on Wan2, what i would like is to assign a specific pc on the network to wan2
11-05-2012 06:13 PM
Look for the protocol binding settings under System Management>Dual WAN>Edit WAN2.
With a ptotocol binding rule, you can bind all traffic originating from a given IP address to WAN2.
11-27-2012 01:00 PM
Hello Alber Idee,
Let me share with you some information found on the guide me section about protocol biding configuration step by step.
I hope this information helps you.
http://sbkb.cisco.com/CiscoSB/ukp.aspx?vw=1&docid=69b1889ee61d42bb9a389bf69fb7bf28_Priority_Bandwidth_magement_using_Rv042.xml&pid=4&fcid=&fpid=&slnid=3
If this answer was satisfactory for you, please mark the question as Answered.
Diego Rodriguez
Cisco network engineer
Thank you
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide