10-19-2012 10:18 AM
What are the IPv6 anycast addresses using for?, are they some kind of broadcast?
I have a router 2811 I'm configuring ipv6, do I need to use these addresses?
I appreciate any help.
Solved! Go to Solution.
10-19-2012 11:17 AM
Good afternoon isaac mora
They are not broadcast addressing, anycast is a network addressing and routing methodology in which datagrams from a single sender are routed to the nearest node (such a domain ¨www.cisco.com¨) in a group of potential receivers all identified by the same destination address.
You do not to configure this feature, just configure the Unicast ipv6 addresses,
Best regards and have a nice day
Johnnatan Rodriguez Miranda
If this answer was satisfactory for you, please mark the question as Answered.
Thank you
10-19-2012 11:17 AM
Good afternoon isaac mora
They are not broadcast addressing, anycast is a network addressing and routing methodology in which datagrams from a single sender are routed to the nearest node (such a domain ¨www.cisco.com¨) in a group of potential receivers all identified by the same destination address.
You do not to configure this feature, just configure the Unicast ipv6 addresses,
Best regards and have a nice day
Johnnatan Rodriguez Miranda
If this answer was satisfactory for you, please mark the question as Answered.
Thank you
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide