04-13-2011 07:41 AM
Is there any good description how to configure Linksys RV016 for two WANs (cable+DSL)? It looks like switching between those two connections not splitting what is set for WAN1 and what is set for WAN2.
I set load balancing as
- WAN1 (cable) all HTTP up/donw should go there
- WAN2 (DSL) GTalk, IMs, SMTP, POP3, IMAP up/down should go there
but looks like is not working that way.
When I will go to speedtest.net and test a connection I always get less amount then connected directly through cable :\ Also when people try to use any session or IP sensitive web site it doesn't let them to log in because session was expired (based on IP) or IP was changed.
Thanks for any help.
04-13-2011 12:31 PM
Adam,
Have you been referencing the Admin Guide on this (page 67 covers Dual WAN configuration for the RV016). Which Load Balancing type are you using (Auto or Group)?
04-13-2011 02:13 PM
Thanks for the Admin Guide. I will take a look ASAP.
About the LoadBalancing - is set to Auto.
04-19-2011 05:59 AM
I follow the guide but without luck - still same problems with the Load Balancing. Any idea what can be wrong? Thanks
10-07-2011 04:57 AM
now I will try setting the internal IP of my server to exit by the sameWAN
I'll post the results here.
10-13-2011 10:00 AM
Marcio good day, as I come dragging this same problem and I have not been solved, found a way to open it right? I have enough time looking how to fix this yet I have. Besides I have other details to this and other Cisco RV082 Linsys RC016, but first I want to resolve this outstanding web sites with sensitive IP not allowed to log on.
10-13-2011 02:46 PM
Hello All,
You should be able to bind any protocol to any WAN port to avoid problems. If Protocol Binding is not working, please call Small Business Support for assistance. You can find a number at the following link: www.cisco.com/go/sbsc
10-13-2011 03:50 PM
Sorry mpyhala , as I commented to me that, from the router, the page or where??? The truth I know little about this and not what you mean. Show me or tell me where to do this, some document or something.
Thanks in advance.
10-13-2011 05:22 PM
Enrique,
On the RV082:
On the RV016:
Please let us know if this helps or if you need further assistance.
10-24-2011 05:01 AM
Success!
However, I had to configure the internal IP of my server to always travel down a specific WAN.
through "System Management> Multi WAN" selected "IP Group (By Users)" and set up like the image below.
I also created a rule that defines all HTTPS traffic by a specific WAN, following the guidance of mpyhala
10-25-2011 09:39 AM
In fact I have already done so, if it works, but the point is not how I wanted to be taking advantage of RV router start the computer, since the idea was to connect my two internet links (modem's) and use both for all my users and this way as I did, as you also would not have worked their case as to account for these users and the https I am pointing to a single WAN.
I think this will be the only alternative solution, and hopefully find some other method or firmware update to correct this little problem of linskys RV.
Thanks in advance.
10-26-2011 03:45 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide