New to VLAN - needs assistance

[acibat0530]

Hi Guys,

I just want to ask how to configure the router to connect to VLANs together.
Please bear with me because I am new to VLANs and Cisco devices and only

familiar with GUI config not the CLI/IOS.

SWITCH 1 SG200 50-50 IP:192.168.1.250

VLAN 10 = PORT 1-20 ACCESS MODE

SWITCH 2 SG200 50-50 IP:192.168.1.251

VLAN 10 = PORT 1-20 ACCESS MODE

They said I would need a router to let these vlans connect to each other so we

bought the Cisco SA 520 router. So from the router where should I start to connect

vlan 10 on switch 1 and vlan 10 switch 2?

I know this is simple to you guys but please show me the initial configuratioin

and I will try to do the rest of it.

Many thanks.

[Sunilks402]

What are you trying to do ?

* give an overview of  physical connectivity at the site

* I see 20 ports in each switch is assigned to same vlan ie vlan 10

* for what purpose are you using this network (internet cafe ?)

[acibat0530]

Hi Sunil,

Our school has plenty of students and staff.

We are planning to segregate the students machines to staff machines plus the new voip and the servers as well.

So the school director suggested to use VLAN and use Cisco switches.

Network Plan:

Router: Cisco SA 520 router

We are all connected in 1 Domain and just want to segregate traffic.

SWITCH 1 SG200 50-50 IP:192.168.1.250

VLAN 10 = PORT 1-10 ACCESS MODE (This is for the Servers & Printers)
VLAN 20 = PORT 11-48 ACCESS MODE (for the Staff)

SWITCH 2 SG200 50-50 IP:192.168.1.251

VLAN 30 = PORT 1-20 ACCESS MODE (for the IP Phones) VOICE

VLAN 40 = PORT 21-48 ACCESS MODE (for Students)

Please bear with me because I am new to cisco devices and work only on GUI.

So I just need some simple tutorial let say if I want:
1. VLAN20 (staff) can access VLAN 10 (servers)

2. VLAN 40 (student) can access VLAN10 (servers)

3. VLAN 40 (student) can access only let say port 1-3 in VLAN 10

4. VLAN 20 and VLAN40 should not have an access.

To help myself as well, I am reading documents about VLANs and trying to understand its configuration

but since we need to setup this soon, I have asked an assistance here.

Hope for your assistance.

Many Thanks.

[acibat0530]

Hi Guys,

Any help will greatly be appreciated on the above scenario.

Thanks in advance.

[Te-Kai Liu]

I suggest you post the question in the Small Business Switches community. You would need a couple of ACL rules to set it up.