RV016 - Wan port is showing half duplex-even though set it as Full duplex

[ptalatichs]

Hi

On RV016 router WAN port 1 is showing Half duplex wen i check it in Port setup but when i check it on Port status its showing me as Half duplex, how can we

force it to make it full duplex.

[adamakers]

I took a look at my RV082 and my wan port is also half duplex but I have auto negotiation enabled so I am assuming that my wan router can only support half duplex.  Are you sure the device you are plugging into your wan port can support full duplex?

-Adam

[ptalatichs]

Hi Adam

Thanks for your reply but i was able to figure it out and make it Full duplex.

I just disable the Auto-negotiate and then forced it to be Full duplex mode and then it was showing as Full duplex.

Pragnesh